Metapace S-62 Manual do Utilizador descarregar pdf (Página 43)

Metapace S-2 Software Manual

How to connect with the target device?

Produce two setup labels for the target SPP slave device, just like what we do for the cradle.

 “Set Connection” label

 “MAC Address” label

Usage:

1. Change the interface to Bluetooth SPP Master and download settings to the scanner.

2. Click the field of “MAC Address of Remote Device” to choose characters from the pop-up

window of Grid Control (see Appendix I

Grid Control). It requires 12 characters.

3. Click [OK] to complete all the settings.

4. Go to Download | Print scanner settings to produce the “Set Connection” and “MAC

Address” labels for printout.

5. Have the scanner read the “Set Connection” and “MAC Address” labels. It will respond with

one beep upon reading each of the labels.

Note: (1) It will automatically add a prefix of “0x” to the real MAC address of the target

device.

(2) Read the “Set Connection” label first, and then the “MAC Address” label within

10 seconds.

Switch between Master/Slave Mode

After the scanner has established a connection as a SPP slave device, change the interface to

Bluetooth SPP Master and download settings to the scanner. It will work as a SPP master device

then.

Note: Switching from SPP Slave to SPP Master does not require a new PIN code. You

must leave it blank or enter exactly the same PIN code for SPP Slave; otherwise, it

will fail to resume connection if a different PIN code is specified.

Exit SPP Master Mode

To stop re-connection, change the interface to Bluetooth SPP Slave and download settings to the

scanner. Alternatively, you may have the scanner read “Reset Connection” or “Restore System

Defaults” label so that the current connection record (= MAC Address) will be cleared. Then, the

scanner will restart itself automatically. Refer to a separate manual for instructions.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 83 84

Sem comentários

Metapace S-62 Manual do Utilizador Página 43